Molex Pin broke off- HELP PLZ

I have an IDE hard drive. Two molex (power) pins out of the four, broke off the other day. See a pic to know what it looks like

AA3ap.jpg

The HDD wont power up any more.

I dont know where the broken pins are. Is there any way i can get the junk repaired?

P.S.

I am from stone age. So please dont suggest that i should put the disk in trash bin. I can use it with my old P4.

You can solder a male 4 contact Molex connector. You can cut off such a connector (with some wire) from a IDE/Molex-to-SATA power extension.

Just make sure to solder the right wire to the right pad.

BTW, please add your location to your profile.

[quote=", post:, topic:"]

I dont know where the broken pins are. Is there any way i can get the junk repaired?
[/quote]

This pin can be pulled out from some dead HDD and then re-soldered to this drive.

If you are not familiar with soldering, any motherboard/mobile repair technician can do that.

I have a good junk of old dead HDDs. If you are in Islamabad, you can have it free of cost :)